TankBot is a controller capable of dosing nutrients, regulating the pH, managing the water tank and even protecting your crop, all this automatically!
You can control any 12v peripheral such as solenoids, peristaltic pumps, etc., while continuously analyzing your tank solution, thanks to pH, EC, temperature and water level sensors.
TankBot also supports any switch sensor, such as smoke or motion detectors, allowing you to detect any problems with your grow!
1 - TankBot
1 - pH Probe
1 - Water/Soil/Air temperature sensor
1 - 4-pin connectors for sensors and actuators (Pack of 4)
1 - 12V Transformer
1 - USB cable
1 - Antenna
*Additional GroLab™ module, one GroNode is necessary to experience the full functionalities of TankBot.
*Each GroNode can control a max of 4 TankBot's.
Warning: Last items in stock!
This module comes with 4 external switches that give the user the ability to manually control all connected peripherals at any time on the spot.
91mm x 108.9mm x 28.7mm
Casing: Stainless Steel
Physical buttons: Reset
USB 2.1 type B
Power Entry 12V/1A 24V/2A
4 x 12v Actuators (2.5mm 4-Pin male)
4 x Switch Sensor (2.5mm 4-Pin male)
2 x Direct Voltage Output (2.5mm 4-Pin male)
Temperature Sensor (2.5mm 4-Pin male)
PH Connector (BNC)
EC Connector (BNC 50Ω)
Yes (Type B-A)
Yes (Type A 230AC-5VDC/2A)
Yes (4 x 2.5mm 4-Pin female)
Radio Frequency - 2.4GHz
2-years limited hardware warranty
140mm (length) x 12mm (diameter)
0PH ~ 14PH
0ºC ~ 80ºC
1-year limited hardware warranty
Casing: Stainless Steel
In its core, TankBot can sample EC/pH and water temperature, these are static inputs available in any TankBot. The pH probe and the water temperature sensor are included with the TankBot.
WATER TEMPERATURE PROBE
Besides that, TankBot comes with 4 controlled outputs and 4 switched inputs. All of them fully configurable via the GroLab™ Software.
Each TankBot output can turn on/off any device that works at 12VDC-24VDC that does not consume more then 6W-12W. Here are some examples of devices you can connect to your TankBot...
ANY KIND OF SOLENOIDS
DC WATER PUMPS
Each TankBot can sense up to 4 switched inputs, what to connect to this inputs is up to you, from water level detectors, smoke detectors or even simple buttons, GroLab™ allows you to sample these sensors and act accordingly. Below you can see some of the switch sensors you can use...